Multi-Tech Systems MT3410ZLX-T/2 - Manual (Page 38)

MultiMobile Owner’s Manual
38
The Modem Does Not Execute the Command Line
C: Make sure you are typing ‘AT’ at the beginning
of command line (and hit Enter at the end).
C: Make sure the modem is not in Data Mode.
Type
+++ if necessary.
C: Make sure your software is set to the same
COMx port as your MT3410ZLX.
The Modem Does Not Give a Response After an
AT Command Was Executed
C: The echo and/or responses may be turned off
by the
ATE0Q1 commands. Enable the AT&V1
to check Result Codes.
S: Use ATE1Q0 then Enter to change them back.
C: Make sure the modem is in Command Mode
and not Data Mode when you type the AT
command.
The Modem Gives an ‘ERROR’ Response After
an AT Command was Executed
C: Make sure you did not type an invalid
command.
C: Make sure your command line is 40 characters
or less.
The Modem Goes Off-Hook and Disables the
Telephone Line.
C: The modem may be set to auto-answer the
phone when it rings.
S: Disable auto-answer by typing ATS0=0 then
Enter at the command line.