Multi-Tech Systems MT3410ZLX-T/2 - Manual (Page 29)

29
3 - Comprehensive Driver Notes
Chapter 3 - Comprehensive Driver Notes
Introduction
This chapter provides general information on the
MT3410ZLX software drivers, as well as specific
information on the NDIS, Packet Driver, and
Windows for Workgroups drivers.
Factory Default Settings
The MT3410ZLX was shipped from the factory with
the following default settings:
Modem COM Port COM3 , IRQ5
LAN IRQ Level 11
LAN I/O Base Addr. 320
Network OS Netware 3.x and 4.x
Frame Type Ethernet 802.2
Target Path C:\NETWARE
Quick Start
For a quick start, simply run INSTALL.EXE, located
at the root directory on the Driver diskette.
PC Card Software - Manual Installation
The installation software has been carefully
designed to detect a combination of hardware and
software installed on the PC. Proper detection
allows the PC’s PC Card drivers to enable the
MT3410ZLX. If the installation software fails, the
enabler must be manually copied from the driver
disk to the PC. If you are using Windows for
Workgroup 3.11, Windows NT, or Windows 95,
follow the instructions for installing PC Cards in your
PC’s manual.