beautypg.com

7getting started (cont.) – Motorola III User Manual

Page 8

background image

7

Getting Started (cont.)

Universal Connector Seal Removal

WARNING:

When not in use, keep the side connector
covered using the universal connector seal
provided.

Touching the top two contacts of the
universal connector when transmitting
could result in a radio frequency burn.

If the universal connector seal is attached to the
radio:

1.

Turn the radio off when removing the seal to
prevent sending an emergency signal should
the emergency button be inadvertently
pressed.

2.

Grasp the radio as illustrated, and push your
thumb against the tabbed portion of the seal
with enough force to unsnap the universal
connector seal from the radio.

Note: An arrow on the top surface of the
s e a l i n d i c a t e s t h e d i r e c t i o n o f t h u m b
pressure to unsnap the seal.

3.

Rotate the seal around the antenna to move
it away from the universal connector; slide
the seal off of the antenna and completely
away from the radio.

Universal

Connector

Seal

Push

Off

Belt Clip Installation and Removal

Note: To avoid damage to the radio's surface,
installation and removal of the belt clip assembly
should be done with the battery removed from
the radio.

Installing the Belt Clip

1.

Insert a pencil or equivalent size instrument
between the inside of the belt clip and the metal
clip assembly so as to hold the metal clip
p a r t i a l l y s p r u n g ( m e t a l c l i p s h o u l d b e
approximately parallel with the plastic portion of
the belt clip).

2.

Align the metal tabs of the belt clip with the
plastic slots of the battery housing.

3.

Slide the belt clip onto the battery, pushing
firmly until a click is heard.

4.

Remove the pencil from the clip.

Removing the Belt Clip

1.

Insert a pencil, or equivalent size instrument
between the inside of the belt clip and the metal
clip assembly so as to hold the metal clip partially
sprung (metal clip should be approximately
parallel with the plastic portion of the belt clip).

2.

Push the flat blade of a #2 slotted screwdriver
(or like instrument) between the battery housing
and the belt clip release tab.

3.

While performing step 2, slide the belt clip out
and away from the battery, and remove the
screwdriver.

4.

Remove the pencil from the clip.

MAEPF-22062-A

MAEPF-22061-O
MAEPF-22062-O

MAEPF-22770-O
MAEPF-22060-O

MAEPF-22060-A

This manual is related to the following products: