Motorola III - Manual (Page 56)

MAEPF-22627-O
E, G, A-F, G, H 55
55 General Radio Features Operation
(cont.)
Trunked Telephone Operation (cont.)
Calling the Last Number Dialed
1. To send a telephone call to the last number dialed,
press the right arrow key ( ) until “PHON” appears
on the display.
Note: If your radio has been so programmed, you
can press the phone button for quick access to the
telephone call feature. This will take you directly to
the ”last number dialed” display shown in step 2; skip
to step 3.
2. Press the key below “PHON.” The display changes to
show the last telephone number dialed. At this point,
either:
3a. If your radio is programmed for immediate access,
the display shows “PLEASE WAIT” while your radio
attempts to access the telephone system. Go to
step 4.
Notes:
• This is a timed message. If you cannot access the
telephone system (no dial tone heard), you will have
to press the HOME key to hang up, and start again
at step 1 of this procedure.
• If you are out of range of the trunked system or the
phone interconnect is out of service, “NO PHONE” is
displayed and a continuous low-pitched tone sounds.
• If the trunked phone interconnect is in use, a busy
tone sounds and “PHONE BUSY” is displayed. Your
number will automatically be dialed when the phone
interconnect becomes available. If you hang up, you
will lose your place in line.
or
3b. If your radio is programmed for delayed access, the
display does not change. Press the PTT switch. The
display shows “PLEASE WAIT” while your radio
attempts to access the telephone system.
Notes:
• This is a timed message. If you cannot access the
telephone system (no dial tone heard), you will have
to press the HOME key to hang up, and start again
at step 1 of this procedure.
• If you are out of range of the trunked system or the
phone interconnect is out of service, “NO PHONE” is
displayed and a continuous low-pitched tone sounds.
HOME
2 A B C 1 3 D E F
6 MNO 5 JKL 4 G H I
7 P R S 8 TUV 9 W X Y
0
1 2 A B C 3 D E F