Motorola III - Manual (Page 54)

MAEPF-22627-O
E, A-H, I 53
53 General Radio Features Operation
(cont.)
Conventional Telephone Operation (cont.)
Making a Manual Access Telephone Call Using the
Keypad (MTS 2000 III Model Only)
1. To make a manual access call using the keypad,
press the right arrow key ( ) until “PHON” appears
on the display.
Note: If your radio has been so programmed, you
can press the phone button for quick access to the
telephone call feature. Skip to step 3.
2. Press the key below “PHON.” The display will show
the last number dialed.
3. Enter the telephone system access code. The
display shows the digits as they are being entered.
Each digit is sent as its key is pressed.
4. If the access was successful, you will hear a dial
tone. If you cannot access the telephone system (no
dial tone heard), go to steps 7 and 8 to hang up,
and start again at step 1 of this procedure.
5. Enter the telephone number. The display shows the
digits as they are being entered. Each digit is sent
as its key is pressed.
6. If the party you are calling answers, carry on with
the conversation in the normal manner. Press the
PTT switch to talk; release the PTT switch to listen.
7. When you have finished your conversation, or if the
number you are calling is busy or does not answer,
you must send the manual hangup code to hang up.
Enter the hangup code. The display shows the digits
as they are being entered. Each digit is sent as its
key is pressed.
8. After the hangup code is sent, press the HOME key
or the phone button to return to the home display.
HOME
2 A B C 1 3 D E F
6 MNO 5 JKL 4 G H I
7 P R S 8 TUV 9 W X Y
0
HOME
2 A B C 1 3 D E F
6 MNO 5 JKL
8 TUV 9 W X Y
0
4 G H I
7 P R S