beautypg.com

19 basic radio operation (cont.), Transmitting – Motorola III User Manual

Page 20

background image

MAEPF-22485-O

19

19

Basic Radio Operation (cont.)

Transmitting

Conventional Modes

1.

Turn the radio on and select the desired zone and

mode (see “Selecting a Zone and Mode”).

2.

(SECURENET-equipped radios only). If the mode is

programmed as neither secure-only nor clear-only,
turn the two-position concentric switch to the
d e s i r e d p o s t i o n ( = S E C U R E N E T v o i c e
transmission; = clear voice transmission).

3. Listen for a transmission and adjust the volume

control for a comfortable listening level. Refer to
step 2 of “Conventional Modes,” “Receiving a Call.”

4.

Do not interrupt another user. If the mode on

which you are transmitting is programmed to
receive PL ( or the proper code if SECURENET-
equipped), ensure that the mode is not in use by
momentarily depressing the monitor button to
listen for activity. If the mode-busy feature is
enabled, a blinking red LED on receive (PTT
released) will indicate that the mode is currently
busy and you should not transmit.

Note: The mode-busy feature is suggested for

SECURENET-equipped radios, since monitoring of
SECURENET activity with a different key will sound
like noise that is nearly indistinguishable from
channel noise.

5.

When the mode is clear, press and hold the PTT

switch on the side of the radio and speak slowly
and clearly into the microphone area. The red LED
w i l l b e l i t c o n t i n u o u s l y w h i l e t h e r a d i o i s
transmitting. When you have finished talking
(transmitting), release the PTT to listen (receive).

Notes:

If a mode is programmed for receive only, any
attempt to transmit on that mode will cause
an invalid-mode tone to sound until the PTT
switch is released.

To take full advantage of the noise-cancelling
feature, avoid blocking the noise-cancelling
port during transmitting.

A

B

C

1

3

5

7

13

15

9

11

LED, red

This manual is related to the following products: