beautypg.com

Motorola T1/E1 User Manual

Page 69

background image

Canopy  T1/E1 Multiplexer 

 

 

 

 

 

 

September 2004 

 

 

 

 

 

 

     

      T1/E1 Multiplexer FPGA Version 3.4 


Page 69 of 73 

Desired Action

Syntax, Response, and Description

Get the timing mode Enter get clock source

The system responds
Clock source set to [loopback/recovered]

Gets the T1 timing mode. This timing mode applies for all four T1 lines.
Loopback mode means to take the T1 Tx clock and loop it back to the
T1 Rx. Recovered mode means to recover the T1 clock from the
incoming T1 over Ethernet bit stream, in other words to recover the
clock from the far end T1.

Get the master
clock reference line

Enter get master clock reference line

The system responds Clk ref line: [1/2/3/4]

NOTE: [1/2/3/4] represents T1/E1 ports 1 through 4.

Displays the T1 master clock reference line. This clock reference
applies for all four T1 lines.

Get the secondary
clock reference line

Enter get secondary clock reference line

The system responds Backup clk ref line; [1/2/3/4]

NOTE: [1/2/3/4] represents T1/E1 ports 1 through 4.

Displays the T1/E1 secondary or backup clock reference line. This
clock reference is the backup clock reference for all four T1/E1 lines.
The backup clock reference will become active only when the master
clock reference line is unavailable.

Issue 3