Ethernet interface, Figure 1: canopy t1/e1 multiplexer with canopy bhs, Figure 1 – Motorola T1/E1 User Manual
Page 10
Canopy T1/E1 Multiplexer
September 2004
T1/E1 Multiplexer FPGA Version 3.4
Page 10 of 73
Figure 1: Canopy T1/E1 Multiplexer with Canopy BHs
The T1/E1 Multiplexer converts the data stream from T1/E1 ports into Ethernet packets
that are then transported over the Canopy BH link. This device can be used to extend
T1/E1 services. You can configure the Canopy T1/E1 Multiplexer to operate as either a
T1 or an E1 device.
Applications of the T1/E1 Multiplexer include
◦
obviating leased lines.
◦
implementing wireless PBX networking.
◦
establishing cellular backhaul links.
◦
providing homeland security backup or emergency voice networks.
◦
routing LAN/WAN data on excess bandwidth.
1.2.1 Ethernet Interface
The Ethernet physical layer auto-negotiation should be set to on for both sides of the
Canopy T1/E1 Multiplexer.
RJ-45 connector pin-outs for the Ethernet cable from the BH to the Canopy port of the
Canopy T1/E1 Multiplexer are illustrated in
Issue 3