License key upgrades, Figure 26: t1/e1 port upgrade window, Figure 27: key accepted window – Motorola T1/E1 User Manual
Page 61
Canopy T1/E1 Multiplexer
September 2004
T1/E1 Multiplexer FPGA Version 3.4
Page 61 of 73
3.7 LICENSE KEY UPGRADES
As previously described, you can transform any single-port enabled Canopy T1/E1
Multiplexer into a 2-port, 3-port, or 4-port multiplexer through the purchase and
installation of license keys from your Canopy distributor.
Procedure 30: Installing a license key to enable an additional port
To install a license key on a Canopy T1/E1 Multiplexer, perform the following steps.
1. From the main menu of the EMS, select Config
→T1/E1 Port Upgrade
Config
→Software Upgrade (shown in
RESULT: The Canopy T1/E1 Port Upgrade window opens, as shown in
Figure 26: T1/E1 Port Upgrade window
2. Type in the upgrade key that your Canopy distributor provided for this unit, then
press Enter.
3. Click
Done.
RESULT: If the upgrade succeeded, then the Key accepted window appears
(see
If the upgrade failed, then the Failed: Invalid key entry window appears (see
Figure 27: Key accepted window
Issue 3