Figure 5: rear panel with optional, 48 v power supply adapter for battery backup – Motorola T1/E1 User Manual
Page 13
Canopy T1/E1 Multiplexer
September 2004
T1/E1 Multiplexer FPGA Version 3.4
Page 13 of 73
Figure 5: Rear panel with optional −48 v power supply adapter for battery backup
The recommended sequence of connection is:
1. Connect a PBX or TDM CPE to the T1/E1 port(s). (See
on Page
2. Connect the Ethernet cable from the Canopy Backhaul Module to the jack
labeled Canopy. (See
3. Connect the selected power adapter to the T1/E1 Multiplexer. (See
and
4. Power the T1/E1 Multiplexer on. (See
5. As required to configure the T1/E1 Multiplexer, connect a notebook computer to
the jack labeled CONTROL on the front panel of the T1/E1 Multiplexer. (See
Issue 3