beautypg.com

Configuration procedures using the cli, Logging into the system, Changing the administrator password – Motorola T1/E1 User Manual

Page 36

background image

Canopy  T1/E1 Multiplexer 

 

 

 

 

 

 

September 2004 

 

 

 

 

 

 

     

      T1/E1 Multiplexer FPGA Version 3.4 


Page 36 of 73 

NOTE:
The default administrator account username is admin.

The default administrator account password is 123.
You cannot change the username. However, you can change the
password at any time. If you forget your password, reset the system
back to the default account and password by logging in, using the safety
account.

The safety account username is safety.

The safety account password is SAFE_qwe.

When you log in using this account, the password for the administrator
account is reset to 123.The system will then log you out, at which point
you may log in using the default administrator account username and
password.

2.4 CONFIGURATION PROCEDURES USING THE CLI 

2.4.1 Logging into the System 

To gain access to the CLI, log into the system as described under Configuration
Procedures Using the EMS.

2.4.2 Changing the Administrator Password 

Procedure 7: Changing Administrator password using the CLI

Use this procedure to use the CLI manager to change the Administrator account
password.

1. Press

Enter.

2. At

the

username

prompt, enter admin.

3. At the password prompt, enter 123.

4. Enter change password.

5. At the prompt Enter your old password: Password:, enter your old

password.

6. At the prompt Enter your new password: Password:, enter your new

password.

7. At the prompt Enter your new password: Password:, re-enter your new

password.
RESULT: The system responds: Password has been changed.

8. To log off, enter lo.

9. Press

Enter.

Issue 3