beautypg.com

Initial configuration procedures, Installing software from the cd-rom, Figure 13: rear panel option 2 – Motorola T1/E1 User Manual

Page 32: 48 v dc polarity, Procedure 5: installing software from the cd-rom

background image

Canopy  T1/E1 Multiplexer 

 

 

 

 

 

 

September 2004 

 

 

 

 

 

 

     

      T1/E1 Multiplexer FPGA Version 3.4 


Page 32 of 73 

Figure 13: Rear panel Option 2: −48 v DC polarity

3. Connect the power cables to an external

−48 v DC supply.

end of procedure

2.3 INITIAL CONFIGURATION PROCEDURES 

2.3.1 Installing Software from the CD‐ROM 

Procedure 5: Installing Software from the CD-ROM

Follow these steps to install the software that is provided by Motorola Canopy on the CD-
ROM onto your PC.

1. Load software onto your PC.

The T1/E1 Multiplexer EMS Graphical User Interface is provided by Canopy on a
CD-ROM that is shipped with the unit.

2. Install the software from the CD-ROM by double-clicking the setup application or

3. Issue

the

Start->Run->d:/setup sequence

where d: is the drive letter of your CD-ROM. If you are using a different drive
letter, simply substitute the appropriate drive letter.

end of procedure

Issue 3