Changing the remote escape character, 5 remote configuration – Multi-Tech Systems MT5634ZBAV User Manual
Page 91

5 Remote Configuration
81
Changing the Remote Escape Character
To increase security, you can change a remote modem’s remote config-
uration escape character. The remote configuration escape character is
stored in register
S9. The factory default is 37, which is the ASCII code
for the percent character (%). Setting
S9 to 0 (zero) disables remote
configuration entirely—but if you do this remotely, you won’t be able to
change it back remotely!
1. Establish a remote configuration link with the remote modem as
described in “Basic Procedure.”
2. Type ATS9=
n, where n is the ASCII code for the new remote con-
figuration escape character, then press ENTER.
3. Save the new value by typing AT&W and pressing ENTER.
4. Type ATO