4 at commands, s-registers, and result codes – Multi-Tech Systems MT5634ZBAV User Manual
Page 73

4 AT Commands, S-Registers, and Result Codes
63
\N4
V.42 reliable mode.If the modem cannot make a
V.42 connection, it disconnects.
\N5
V.42, MNP, or non-error correction (same as
\N3).
\N7
V.42, MNP, or non-error correction (same as
\N3).
Command:
\Q
n
Flow Control Selection
Values:
n = 0, 1, or 3
Default:
3
Description:
\Q0
Disable flow control (same as
&K0).
\Q1
XON/XOFF software flow control (same as
&K4).
\Q2
CTS-only flow control. Not supported.
\Q3
RTS/CTS hardware flow control (same as
&K3).
Command:
\T
n
Inactivity Timer
Values:
n = 0, 1–255
Default:
0
Description:
\Tn
Sets the time (in minutes) after the last character
is sent or received that the modem waits before
disconnecting. A value of zero disables the timer.
Applies only in buffer mode.
Note: You can also set the inactivity timer by changing the value of
S30.
Command:
\V
n
Protocol Result Code
Values:
n = 0, 1, or 2
Default:
1
Description:
\V0
Disable the appending of the protocol result code
to the DCE speed.
\V1
Enable the appending of the protocol result code
to the DCE speed.
\V2
Same as
\V1.