Entering the access number – Minolta CF910 User Manual
Page 29
2-11
6. Auxiliary Functions
Gettin
g
to
Kn
o
w
Y
o
ur
C
o
p
ier
Chapter 2
If an access number has been programmed, it
allows only particular persons to use the copier or
a supervisor to keep track of the number of copies
made by a particular department.
NOTES
• If an access number has been programmed, a
copy cycle can be initiated only after the access
number has been input to the copier.
• Before you can use this function, you must first
turn “ON” the “Copy Track” function of the
Administrator Mode available from User’s
Choice. ☞ p. 5-3
Entering the Access Number
Using the 10-Key Pad, enter the 4-digit
access number and press the OK Key.
NOTE
To correct the 4-digit access number entered,
first press the Clear Key, then enter the new
number.
The Touch Panel changes from the “Access
#” prompt to the initial screen. A copy cycle
can now be started. Make your copies as
necessary.
When the copy cycle is completed, press the
Access Mode Key to go to the “Access #
Prompt Screen.”
Access Number
<“Access #” Prompt Screen>
1154P449CA
1
1154O401
1
2
3
4
5
6
7
8
9
0
C
2
3