Motorola i2000 - Manual (Page 105)

103
Safety and General Information
For the Safe and Efficient Operation of Your Radio, Observe These
Guidelines:
Your radio product contains a transmitter and a receiver. When it is ON, it
receives and transmits radio frequency (RF) energy. The radio operates in the
frequency range of 806 MHz to 870
MHz or 890 MHz to 960 MHz, and
employs digital modulation techniques. When you communicate with your radio
product, the system handling your call controls the power level at which your
radio product transmits. The output power level typically may vary over a range
from 0.00024 watts to 0.6 watts at, or below, 870MHz, and 0.001 watts to 3.2
watts at, or above, 890 MHz.
Exposure To Radio Frequency Energy
Your Motorola Radio Product is designed to comply with the following national
and international standards and guidelines regarding exposure of human beings
to radio frequency electromagnetic energy:
• United States Federal Communications Commission, Code of Federal
Regulations; 47 CFR part 2 sub-part J
• American National Standards Institute (ANSI) IEEE. C95. 1-1992
• National Council on Radiation Protection and Measurements (NCRP).
Report 86
• International Commission on Non-Ionizing Radiation Protection (ICNIRP)
1998
• National Radiological Protection Board of the United Kingdom,
GS 11, 1988
• Verband Deutscher Elektrotechniker (VDE) DIN-0848
• Department of Health and Welfare Canada. Safety Code 6
To assure optimal radio product performance and make sure human exposure to
radio frequency electromagnetic energy is within the guidelines set forth in the
above standards, always adhere to the following procedures:
When placing or receiving a phone call, or using the group and private call
functions with a Group/Private Speaker OFF (muted speaker icon visible in the
IMPORTANT INFORMATION ON SAFE AND EFFICIENT
OPERATION.
READ THIS INFORMATION BEFORE USING YOUR
INTEGRATED MULTI-SERVICE PORTABLE RADIO.