Muratec M860 - Manual (Page 74)

Answering Machine
4.15
Paging
Your fax machine can call you whenever a caller leaves a message on your
answering machine. This paging feature is very helpful when you are expecting an
important message but can’t sit by the phone.
Using paging is simple. You specify a telephone number ---- the page number ----
for the fax to call whenever you receive a message on the answering machine.
Then you turn on the pager function. Now, every time the fax’s answering
machine stores an incoming message, it will call the pager number. Upon
answering, you will hear a beeping; this tells you that your fax is paging you.
Then you perform a simple retrieval function and hear your message!
The fax will try to call the pager number after each message is saved on the
answering machine. If the unit encounters a busy signal or if it does not receive an
answer, it will automatically redial the pager number.
How many times it redials is something you can set (see “Set The Number of
Pager Calls,” right column).
Note: The fax’s paging function works only with voice messages stored on its
answering machine. For information on Muratec fax models which allow
“fax retrieval” from remote fax machines, please contact your authorized
Muratec retailer.
Setting the pager number
To set the pager number:
1. Press program , 9 , mode/enter , 6 .
Set Pager Number
2. Press mode/enter .
3. Use the numeric keypad to enter the desired telephone number, up to 40
characters in length (including special dialing characters as needed or helpful -
--- see page 2.4).
4. Press mode/enter . The fax will return to standby mode.
Turning on paging
To activate the paging function so your fax machine will page you after it receives
an incoming message on the answering machine:
1. Make sure you have entered a pager number and that the pager number
currently stored is the desired one. If necessary, repeat the procedure
described under “Setting the Pager Number”.
Note: If there is no pager number stored, or if the pager number were erased,
the fax will not allow activation of the paging function.
2. Press answer to instruct the fax to answer calls automatically. The “answer”
lamp will light.
3. Press program , 9 , mode/enter , 7 .
Set Pager
4. Press mode/enter . The LCD will show:
Pager OFF
5. Press program .
Pager ON
Note: If you haven’t set a pager number, the fax will beep three times and
briefly display:
Set Pager Number
---- reminding you to set the pager number (see left column).
The fax will return to standby mode without having turned on the Pager
function. Set the pager number, then repeat this procedure from step 1.
6. Press mode/enter . The fax will return to standby and the “Pager” lamp will
light.
Turning off paging
To turn off the pager function, repeat the procedure shown under “Turning On
Paging” ---- except that in Step 5, when you press
program , the LCD will show:
Pager OFF
---- and, when you finish, the Pager lamp will be off.
Set the number of pager calls
When your fax machine encounters a busy signal or when it does not receive an
answer, it will automatically attempt to redial the pager number.
To set the pager number:
1. Press program , 9 , mode/enter , 8 .
# of Pager Call
2. Press mode/enter .
# of Dials = 1
3. Use the numeric keypad to enter the desired number of times. You may choose
between 1 and 5 times.
4. When done, press mode/enter . The fax will return to standby mode.