Muratec M860 - Manual (Page 41)

Beyond the Basics
2.10
Delayed Transmission
Take advantage of lower evening long distance rates with delayed transmission.
Your fax can store one delayed transmission command, which you can program
up to 31 days in advance. However, it is necessary for the fax document to be in
the feeder at the moment when you want the machine to send the fax.
Setting up A Delayed Transmission
Important: Your machine remembers only the day of the month, not the month
itself, when it’s supposed to perform a delayed transmission. So, if,
say, you want your fax to do something at 5:05 PM on June 26, don’t
make that setting sooner than 5:06 PM on May 26.
To set up a delayed transmission:
1. Insert the document.
2. Press program .
Delayed Trans.
3. Press mode/enter .
Time : 12,11:30
4. Use the numeric keypad to enter the date, hour and minute when you want
your fax machine to carry out the delayed transmission.
In the example, the 12th is the date for the delayed transmission, and 11:30
AM is the time scheduled. (Remember that we’re using 24-hour time format;
11:30 PM would be expressed as 23:30.)
Note: To move the cursor to a specific digit, press the one-touch key a to
move the leftward, or press the one-touch key b to move the rightward,
to that digit.
5. After entering the desired date and time, press mode/enter .
6. Enter the fax number to which the delayed transmission should go. You may
either press a one-touch key, enter a speed-dial number or just use the numeric
keypad normally.
123-4567
Note: If you make a mistake or want to erase characters entered in a previous
setting, press contrast/cancel to erase leftward. Or, if you want to
change just one character in the number, press the one-touch a to move
the cursor leftward or press the one-touch b to move it rightward, to that
character. Then re-enter until the number is just as you want it.
7. Press start . Your fax machine will return to standby with a “Reserved” notice,
like this:
Reserved
This means your fax machine has stored a delayed transmission command.
While reserved, the machine can receive documents but cannot transmit.
Reviewing or Canceling a Delayed
Command
If you’ve stored a delayed transmission command in your fax machine or if you
attempt a fax transmission and your machine cannot make contact (for example,
due to a busy signal), it will hold the transmission command ---- and the original
document involved ---- until it carries it out successfully, it reaches its maximum
number of redial attempts (see page 1.17), or you cancel the command. If you
wish to review or cancel the command, here’s how:
1. Press program , 5 .
Review Command
2. Press mode/enter .
COM1 : 123-4567
In the example above, the fax machine is holding a command for a delayed
transmission to phone number 123-4567. Also, if a “right-now” transmission
attempt to the same number has been blocked by a busy signal, you’ll see the
above one.
3. When you wish to erase the command, press contrast/cancel .
COM1 : Erased
If you decide not to cancel the command, press stop .
And;
the delayed transmission command is able to cancel by pressing stop .