Temp – Middleby Marshall RED LOBSTER PS200-R68 User Manual
Page 36
30
SECTION 3
OPERATION
B. Temperature Controller Operation Instructions
1.
UNLOCKING SET POINT. The temperature controller set point must be 450°F (232.2°C) for the upper oven and
350°F (176.7°C) for the lower oven. To raise or lower the set point on a Red Lobster oven the set point must first
be unlocked by pressing the Lower Left Blank and the Lower Right Blank keys simultaneously. The set point will
remain unlocked for 60 seconds or until the DISPLAY key is pressed.
a.
Raising the temperature set point. Refer to Figure 3-7.
AA. Slow Method: 1 Degree increments.
Press the UP Arrow Button (
▲
). The temperature set point will
increase one degree. If this button is kept depressed, the tempera-
ture set point will continue to increase in one degree increments.
BB. Fast Method: 10 Degree increments.
Press and hold the UP Arrow Button (
▲
). The temperature set point
will begin to increase one degree at a time. With your other hand,
press the DOWN Arrow Button (
▼
) and release. The temperature
set point will begin increasing in 10 degree increments.
CC.Fast Method: 100 Degree increments.
Press and Hold the UP Arrow Button (
▲
). The temperature set point
will begin to increase by one degree at a time. With your other hand,
press the DOWN Arrow Button (
▼
) once and release. The tempera-
ture set point will begin increasing in 10 degree increments. Press
the DOWN Arrow Button (
▼
) again and release. The temperature
set point will begin increasing in 100 degree increments. See Figure
3-7.
b. Lowering the temperature set point.
AA. Follow the previous steps AA through CC for raising the temperature set point but use the opposite UP/DOWN
Arrow Buttons.
2.
Displaying the actual oven temperature. Refer to Figure 3-8.
a.
To check the oven temperature press the DISPLAY Button once
and the actual oven temperature and the word “TEMP” will be displayed.
See Figure 3-8.
b. Press the DISPLAY Button again and the display will return to the
temperature set point. If the DISP key is not pressed, then the display
will automatically return to the temperature set point after 60 seconds.
Middleby Marshall
ALM
HEAT
351
S E T P T
1
FUNCTION
DISPLAY
RESET
SET UP
F
Figure 3-7
Lower Left
Blank
Lower Right
Blank
Figure 3-8
Middleby Marshall
ALM
HEAT
351
TEMP
1
FUNCTION
DISPLAY
RESET
SET UP
F