Middleby Marshall RED LOBSTER PS200-R68 - Manual (Page 29)

23
SECTION 2
INSTALLATION
It is possible to convert ovens from natural gas to propane
and back. Call your local authorized factory service agent
to perform the conversion.
NOTE: In Canada to conform with CAN/CGA-B149.2
Propane Installation Code the oven must be ordered
Propane, it may not be converted in the field.
X. CONVEYOR BACKSTOP AND END STOP IN-
STALLATION
Locate the conveyor backstop and end stop in the
installation kit. Install the backstop and end stop at the
exit end of the oven. Refer to Figure 2-14.
Conveyor
Rear Stop
Figure 2-14.
Installing Backstop and End Stop
Incoming
Pressure Tap
(Where
incoming gas
pressure is
measured)
Manual
Shutoff Valve
Gas Cock
located below
machinery
compartment
On/Off Knob-
Always Leave
In On Position
Combination
Gas Control
Valve
High
Flame
Solenoid
Valve
Low
Flame
Bypass
Line
Pilot Line
Burner Blower
Air Adjustment
Plate
Outlet
Pressure
Tap
Figure 2-13. Gas Train
Middleby
Marshall
Conveyor
End Stop