McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 240)

9
9-32 McDATA UltraNet Edge 3000 User Guide
Configuring Tape Device Extension
If Edge LUN mapping is not necessary, proceed to the
“Delivering the Configured Network” section in this chapter.
NOTE: See the examples in the “Network Configuration Examples” section
to determine if your network needs static LUN mapping and source WWN
filtering.
Static Mapping the
LUNs and Filtering
the Source WWN Use the following procedure to statically map the Edge LUNs and
add filtering to the source WWN. Use Table 8-4 and Table 8-5
(page -7) for an example of how the LUNs and WWNs are used in the
following procedure. For purposes of illustrating an example, the
screens shown below follow the table information in the “Network
Configuration Examples” (page -2) section.
Mapping Node 10 to
WWNs Accessed by
Node 20
1. Double-click on the Device Extension interface 10 on
Node 10.
2. Click the Peripheral tab and define the WWNs being accessed by
Node 20 in the WWN field.