Gateway E SERIES E-6000 - Manual (Page 108)

102
Chapter 7: Adding or Replacing Components
www.gateway.com
5
Set any jumpers on the new drive to match the old drive. See the drive
documentation for further instructions.
6
Slide the new drive in, then slide the release lever toward the inside of the
case.
7
Reconnect the drive cables using your notes from Step 2. The red-striped
edge of the data ribbon cable indicates Pin 1 and corresponds with Pin 1
on the drive (typically on the side farthest from the power supply
connection). For more information, see the drive documentation.
8
Close the case by following the instructions in “Closing the case” on
page 95.