Genicom GEK 00031B - Manual (Page 114)

Chapter 5. Proprinter Emulation GEK-00029B 114
ESC 3 n Set Graphics Line Spacing: Sets the line spacing to n units of 1/216
inch. This allows for line spacing in .0046 inch increments to 1.18
inches (255/216). The value of n/216 is rounded up to the next
1/144 inch.
n = 1 through 255
Example: ESC 3 27 Sets the line spacing to 1/8 inch, or
27/216.
Decimal: 27 51
Hex: 1B 33
BASIC: CHR$(27);"3";
ESC 4 Set Top of Form: Sets current paper position as top of form.
Decimal:
27 52
Hex: 1B 34
BASIC: CHR$(27);"4";
ESC 5 n Automatic Line Feed: Printer automatically does a line feed after
receiving a carriage return.
n = 0, disabled
n = 1, enabled
Decimal: 27 53
Hex: 1B 35
BASIC: CHR$(27);"5";
ESC 6 Select Character Set 2: All characters (printable and control codes)
received after this command are selected from character set 2. A
reset, initialization, or ESC 7 resets to character set 1.
Decimal: 27 54
Hex: 1B 36
BASIC: CHR$(27);"6";
ESC 7 Select Character Set 1: All characters (printable and control codes)
received after this command are selected from character set 1. Also,
see ESC 6 above.
Decimal: 27 55
Hex: 1B 37
BASIC: CHR$(27):"7";
ESC A n Stores n/72-inch Line Spacing: The text line spacing is stored,
although not set for use, to the value n in units of 1/72 inch. An ESC
2 must be sent to start this line spacing. Valid parameter values are
1 through 85.
Decimal: 27 65
Hex: 1B 41
BASIC: CHR$(27);"A";