Genicom 3600 User Manual
3600 bar code label printer
Table of contents
Document Outline
- Contents
- Before You Begin
- Chapter 1 - General Information
- Chapter 2 - Preventive Maintenance
- Chapter 3 - Testing and Adjusting
- Chapter 4 - Troubleshooting
- Chapter 5 - Remove and Replace Procedures
- Replacing the Lithium Battery
- Replacing the Printhead
- Replacing the Bezel PCB
- Replacing the Main PCB
- Replacing the Kanji/Katakana Option PCB
- Replacing Printer Components
- Replacing the Label Mark Sensor
- Replacing the Label Taken Sensor
- Replacing the Label Gap Sensor
- Replacing the TTR Drive Roller and Gear/Pulley
- Replacing the TTR Takeup Hub, Clutch/Pulley, and Belt
- Replacing the TTR Supply Hub and Adjusting Plate
- Replacing the Platen Roller and Gear
- Replacing the Liner Drive and Takeup Components
- Replacing the Stepper Motor
- Replacing the AC Plug/Input Filter
- Replacing the Power Switch/Circuit Breaker
- Replacing the Transformer
- Chapter 6 - PCB Drawings and Schematics
- Chapter 7 - Replacement Parts
- Appendix A - Theory of Operation