Using frames, Svp function keys, 3 using frames – Fujitsu Siemens Computers BS2000/OSD User Manual

Page 42

U25339-J-Z126-1-7600

Using frames

Standard processing in SVP mode

6.3 Using frames

You assign a job to the SVP by invoking the relevant frame, selecting the desired function,
and specifying the required parameters. To select a function or specify a parameter, you
must enter the alphanumeric characters shown in the frame in the input fields marked by an
arrow (

). The input fields can be selected with the tab key

. Once you have entered all

the functions and parameters assigned to a job, press the

key. In several frames,

functions can also be initiated with the SVP function keys.

Instead of selecting a function, you can also enter a command in the command input line in
all frames (screen line 24) and assign a job to the SVP in this way. Frames can also be
selected using the

FRËFrame-ID

, e.g.

FR ML

(to switch to the MODE SELECTION FRAME).

A command entered in line 24 takes priority over a selected frame function.

General notes on frame operation:

The input is disturbed by the output of messages in line 23 (e.g.

SET TIME COMMAND

COMPLETED

). The

key suppresses output of the message for one minute. In this time the

frame can be filled out and dispatched with

6.3.1

SVP function keys

An EMDS keyboard mask, which must be ordered separately, is used to operate the
SVP frames:

Order number: U20076-J-Z148-1
EMDS (SINIX Open Desktop) as of V2.1 for DSS 97801-5xx:
Keyboard masks - 6 strips

The following diagram shows the position and labelling of the SVP function keys on the
EMDS keyboard mask:

You can activate various functions on the SVP frames with the help of the P keys

the keys

and

ENTER

P10

P11

P12

P13

P14

P15

P16

P17

P18

P19

P20

P20