Fujitsu Siemens Computers BS2000/OSD - Manual (Page 33)

U25339-J-Z126-1-7600 33
6 Standard processing in SVP mode
Jobs are assigned to the service processor via special SVP menus, so-called SVP frames.
All the information you require as an operator working with SVP frames can be found in this
chapter. You will find instructions on the use of all user frames in the original “GS8600
MODEL GROUP OPERATORS GUIDE” (FJ-No. C112-E015-01EN).
After switching on the S130 and 3970-SKP, BS2000 operation must be prepared, i.e. the
BS2000 operating system must be loaded (IPL = Initial Program Load). The following activ-
ities may be required for the IPL:
– select the IORSF (Input/Output Resource File) and start the IMPL (Initial Micro Program
Load)
This is only necessary if you want to load another IORSF.
– specify the operating mode (Native/VM2000)
This is only necessary if you want to change the mode setting.
– start IPL using PROGRAM LOAD FRAME
To do this you may have to redefine device parameters in the DETAIL-1 frame.
– configure an automatic IPL (POWER ON IPL)
The following sections provide examples of standard processing relevant to loading
BS2000. There is also an description of how to select a particular configuration and how to
re-initialize the SVP.
Standard processing at the SKP operator terminal at a glance:
– selecting IORSF
– re-initializing SVP
– setting up PROGRAM LOAD FRAME: PRESET-1
– setting up PROGRAM LOAD FRAME: PRESET-2
– selecting the SSU configuration
– setting the operating mode using PROGRAM LOAD FRAME: DETAIL-2 for loading
BS2000 / VM2000
– executing IPL in PROGRAM LOAD FRAME: DETAIL-1
All standard processing is carried out at the SKP operating terminal via the X window
system, SVPST0 #1 (computer name) window.
Ê Select the SVP window by clicking with the left mouse mouse button
(see chapter “Operating the X window system” in the “SINIX-2000 V7.0” [1] manual).