FUJITSU MHR2030AT - Manual (Page 126)

Interface
5-52 C141-E145-02EN
At command issuance (I/O registers setting contents)
1F7
H
(CM) 1 1 1 1 1 0 0 1
1F6
H
(DH) x x x DV xx
1F5
H
(CH)
1F4
H
(CL)
1F3
H
(SN)
xx
xx
xx
1F2
H
(SC) xx
1F1
H
(FR) 02
At command completion (I/O registers contents to be read)
1F7
H
(ST) Status information
1F6
H
(DH)
1F5
H
(CH)
1F4
H
(CL)
1F3
H
(SN)
1F2
H
(SC)
xx
xx
xx
xx
xx
1F1
H
(ER) Error information
• SET MAX UNLOCK (FR = 03h)
This command requests a transfer of single sector of data from the host, and
defines the contents of SET MAX ADDRESS password.
The password supplied in the sector of data transferred shall be compared with the
stored password.
If the password compare fails, the device returns command aborted and
decrements the Unlock counter, and remains in the Set Max Lock state. On the
acceptance of the SET MAX LOCK command, the Unlock counter is set to a
value of five. When this counter reaches zero, then SET MAX UNLOCK
command returns command aborted until a power cycle.
If the password compare matches, then the device makes a transition to the Set
Max Unlocked state and all SET MAX commands will be accepted.
The READ NATIVE MAX ADDRESS command is not executed just before this
command. The command is the SET MAX ADDRESS command if it is the
command just after the READ NATIVE MAX ADDRESS command is executed.