Furuno GPS NAVIGATOR GP-150 - Manual (Page 58)

8. MENU SETTINGS
8-10
Loading completed
Valid waypoint : 0
Invalid waypoint : 0
Press any key
Figure 8-21
8) Press the MENU ESC key twice.
Saving data to personal computer
Waypoint and route data can be saved to a
personal computer.
1) Press MENU ESC, 9 and 5.
2) Press or to select Level.
3) Press or to select level; RS232C
or RS422.
4) Press the NU/CU ENT key. "Data"
appears in reverse video.
5) Press to select Com.
6) Press to select Next Page.
7) Press or to select Baud Rate.
8) Press or to select baud rate;
4800bps, 9600bps, or 19200bps.
9) Press to select Command (under the
Save Data line). Stop, on the same line
as Command, appears in reverse video.
10) Press to select Start. The message
shown in Figure 8-22 appears.
Are you sure to save ?
ENT: Yes MENU:No
Figure 8-22
11) Press the NU/CU ENT key. The message
shown in Figure 8-23 appears while data
is being saved.
Now saving
Waypoint/Route data !
MENU:Stop
Figure 8-23
12) Save data at the computer.
13) Press the MENU ESC key. When data is
saved, the cursor shifts to Stop.
14) Press the MENU ESC key.
8.6 WAAS/DGPS Setting
This menu sets the using WAAS or when the
DGPS beacon receiver GR-80 is connected.
The default setting is “GPS”.
WAAS
1) Press MENU ESC, 9 and 7 to display the
WAAS/DGPS SETUP menu.
WAAS Search AUTO MAN (GEO=134)
FREQ 323.0kHz
Baud Rate 200 bps
WAAS/DGPS SETUP
MENU : Escape ENT : Enter
: Select
Mode Of GPS
Corrections Data Set
*
: 00
DGPS Station AUTO MAN List
*: Determines how to use the WAAS signal.
Use the default setting "00".
Figure 8-24 WAAS/DGPS SETUP menu
2) Press or to select WAAS or AUTO.
3) Press to select WAAS Search.
4) Press or to select AUTO or MAN.