Furuno GPS NAVIGATOR GP-150 - Manual (Page 26)

4. NAVIGATION PLANNING
4-2
6) Press to select waypoint mark shape.
The following display appears.
: Cursor
ENT: Enter MENU: Escape
Figure 4-4 Screen for selecting waypoint
mark shape
7) Press or to select mark shape.
8) Press the NU/CU ENT key. The display
shown in Figure 4-5 appears.
ENT: Set MENU: Escape
ABCDE FGHIJ KLMNO PQRST UVWXYZ
abcde
: Cursor
A
fghij klmno pqrst uvwxyz
ENTER
Comment :
1 2 3 4 5 6 7 8 9 0 _ # % ’ ( ) + - . / : ; < = > ?
_ _ _ _ _ _ _ _ _ _ _ _
Figure 4-5 Screen for entry of
comment for waypoint
9) You may enter a comment, as shown in
the procedure which follows, or skip to
step 10 to finish. The comment may
consist of up to 12 alphanumeric
characters.
1 Press the cursor keys to select
alphanumeric character.
2 Press the NU/CU ENT key. Selected
character appears on the COMMENT
line.
٠ To create a space, select "_".
٠ Numeric data can be input directly by
pressing numeric keys.
٠ To clear wrong data, press the
CLEAR key.
3 Repeat steps 1 and 2 to complete the
comment.
4 Select ENTER and press the NU/CU
ENT key.
10) Press the NU/CU ENT key.
Control is returned to the last used
display mode.
When the waypoint number entered at
step 5 already exists, the message
shown in Figure 4-4 appears if the
waypoint is part of the current destination
or route or is part of a route. If it is alright
to write over the waypoint and its data,
press the NU/CU ENT key. To change
waypoint number, press the MENU ESC
key.
This WPT is GOTO
This WPT is in registered route
This WPT is in selected route
1st line
Are you sure to change ?
ENT: Yes MENU: No
Figure 4-6
Note: If you fail to enter waypoint number,
"Enter waypoint number" appears on
the display for three seconds.