Furuno GPS NAVIGATOR GP-150 - Manual (Page 41)

6-1
6. SETTING UP
VARIOUS
DISPLAYS
6.1 Selecting Data to Display
on the Data Display
The user may select what data to display in
four locations on the data display.
JAN 12, 2009 23:59’59" U
12 23.456’ N
123 23.456’ E
Position
RNG
31.23
NM
SOG
12.3
kn
BRG
223.4
COG
123.4
TO : 001
MARINE
POINT1
NEXT
: 002
MARINE
POINT2
User-defined
display data #1
User-defined
display data #2
User-defined
display data #4
User-defined
display data #3
User-defined
display window
W84
D3D 100m
* * SAFE
Figure 6-1 Data display
The data the user may select to display are;
•
Altitude (ALT)*
• Average course (AVR COG)
• Average speed (AVR SOG)
•
Course (COG)
• Course error (dCOG)
• Cross track error (XTE)
•
Depth (WAT DPTH)#
• Drift (DRIFT)
• ETA to waypoint (ETA)
•
Heading (HDG)
• Range to waypoint (RNG)
• Bearing to waypoint (BRG)
• Route time-to-go (ROUTE TTG)
•
Set (SET)
• Speed over ground (SOG)
• Speed thru water (STW)
•
Time-to-go to waypoint (TTG)
•
ETA to route (ROUTE ETA)
• Total route distance (ROUTE DIST)*
• Trip distance (TRIP)
•
Trip elapsed time (TRIP TIME)
• Water temperature (WAT TEMP)#, and
• Velocity to destination (VTD)*
*ALT: Displayed only in 3D position fixing.
*ROUTE DIST: Total distance from current
position to ultimate destination. Appears
when following a registered route or a
cursor-created route.
*VTD: When following a route, plus or minus
appears next to indication to denote which
direction the route is being traversed.
# Requires external sensor.
1) Press MENU ESC, 9 and 1 to display the
PLOTTER SETUP menu.
PLOTTER SETUP
Bearing REF
AUTO
(07 W)
MAN
(00 E)
ENT:Enter MENU:Escape
Memory Apportion
MAG Variation
True
TRK = 1000 / 2000Pt
MAG
RL GC Calculation
User defined #1 SOG
User defined #2 COG
User defined #3 RNG
User defined #4 BRG
Figure 6-2 PLOTTER SETUP menu
2) Press or to select one of four of
"User defined" (#1, #2, #3, #4).
3) Press or to select data to display.
4) Press the NU/CU ENT key. To select the
data to display at other user defined
displays, repeat steps 2 and 3.
5) Press the MENU ESC key.