FARGO electronic HDP600 - Manual (Page 313)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3) 11-11
Setting the Transfer EOF (continued)
Step Procedure
3 Determine the amount of Transfer EOF adjustment needed by using a caliper
to measure the
“
Gap
”
.

The Gap: Represents the distance from the Trailing Edge of the card to
the edge of the image as shown below

See Using the Gap Distance Table. This table will convert this
“
Gap
”
distance into an approximate adjustment value.