FARGO electronic HDP600 - Manual (Page 144)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3) 5-6
Network Management Interface
The SNMP interface is described below.
Interface Description
SNMP

The Ethernet interface is a fully-manageable SNMP agent that supports
MIB-II.

The Ethernet interface is MIB II compliant, allowing SNMP managers to
monitor protocol, network and routing statistics.
Telnet Command Line Interface
Initiating a Telnet Session
This procedure shows how to initiate a Telnet session from a PC in order to access the
Telnet services provided by the Printer. Follow these instructions to issue Telnet commands.
Step Description
1 Identify the IP address of your Printer. (Note: See the Accessing the IP
address of your Printer .)
2 Initiate a Telnet session from a DOS window on your PC. At the DOS prompt,
enter telnet [IP Address]
Example: C:\>telenet 192.168.11.12

All Telnet responses from the Printer will then be displayed in the
Telnet session on the PC.

All commands entered will be sent to the Telnet client in the Printer.
3 Enter help or ? to get an on-window list of supported Telnet commands.