FARGO electronic HDP600 - Manual (Page 281)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3) 7-70
Selecting the Lamination Type
Step Procedure
1 Select one of the Lamination Type options, according to which type of
Lamination media is currently installed. Two types of overlaminates are
supported by the Driver: Film Lamination and PolyGuard Lamination.
Custom versions of each type are also available.

Select the Film Lamination option if the Thermal Transfer Film
Overlaminate type is installed in the Lamination Module.

Select the 0.6 PolyGuard Lamination option or 1.0 PolyGuard
Lamination option for either patch thickness. (Note: These require
different heat settings and Lamination speeds. Select the appropriate
option according to the thickness of the PolyGuard material you are
using.)

Select the PolyGuard Alternating Patch option only if using
PolyGuard material that has alternating patch configurations on the
same roll (e.g., full patch on the front of the card and half patch on the
back).