Board errors, Board errors -2, Resolving the ee memory error -2 – FARGO electronic HDP600 User Manual
Page 297: Resolving the ee checksum error -2, Resolving the ee checksum error
RESTRICTED USE ONLY
Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3)
10-2
Board Errors
Resolving the EE Memory Error
Symptom: An error has occurred in the permanent circuit memory. (Note: The Printer
’
s
LCD will state the following: EEPROM ERASED.)
Step
Procedure
1
Reboot the Printer.
2
If the problem persists, the Main Print Board will need to be replaced.
3
As an alternative to replacing the Main Print Board, the chip U21 may be
replaced. (Note: Fargo recommends that only a qualified electronics
technician perform this procedure.)
Resolving the EE Checksum Error
Symptom: An error has occurred in the permanent circuit memory.
Step
Procedure
1
Reboot the Printer.
2
If the problem persists, the Main Print Board will need to be replaced.
3
As an alternative to replacing the Main Print Board, the chip U21 may be
replaced. (Note: Fargo recommends that only a qualified electronics
technician perform this procedure.)