FUJITSU PRIMERGY B120 - Manual (Page 58)

System components and expansions Accessible drives
50 A26361-K646-Z102-1-7619
8.2.2 Changing the floppy disk drive
Ê Shut down the operating system.
Ê Switch off the server, and disconnect it from the network.
!
Switching off the server does not disconnect the device from the network. To completely
disconnect the device from the network, remove the power plug from the line voltage.
Ê Open the server (see " Opening and closing the server ").
1
2
3
Ê Disconnect the cables from the floppy disk drive (1).
Ê Remove the fastening screw (2) and withdraw the floppy disk drive from the bay (3).
Ê Push the new floppy disk drive into the bay and secure it with the screw you removed earlier.
Ê Connect the cables to the floppy disk drive again.
Ê Close the server again (see " Opening and closing the server ").