FUJITSU PRIMERGY B120 - Manual (Page 25)

Installing rack-server in/removing from rack Installation
A26361-K646-Z102-1-7619 17
3.5.2 Installing the slide-in module
The server requires five height units. The sliding rails are mounted in the bottom height unit. One
height unit is equal to 4.445 cm = 1 ¾ inches.
Fitting spring nuts
2
3
ca 45°
4
5
5
1
Ê Insert the spring nuts in the corresponding groove of the support upright at the mounting points
for the sliding rails and the server (1 - 4).
Ê If necessary, adjust the position of the nuts in the groove until they lock into the correct position
(5).