FUJITSU PRIMERGY B120 - Manual (Page 57)

Accessible drives System components and expansions
A26361-K646-Z102-1-7619 49
8.2.1 Installing/Removing an accessible 5 ¼-inch drive
Ê Shut down the operating system.
Ê Switch off the server, and disconnect it from the network.
!
Switching off the server does not disconnect the device from the network. To completely
disconnect the device from the network, remove the power plug from the line voltage.
Ê Open the server (see " Opening and closing the server ").
1
2
3
Ê Disconnect the cables from the drive (1).
Ê Remove the two fastening screws (2) and take out the drive toward the front (3).
The new drive is mounted in reverse order.
If you do not install a new drive, proceed as follows:
1
a 2
b
Ê Mount an EMC insert (a) and a plastic cover (b) in the empty bay (1 + 2).
Ê Close the server again (see " Opening and closing the server ").