FARGO electronic HDP5000 - Manual (Page 80)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4) 4-4
Installation and Removal Procedures Flipper and
Lamination Modules
Removing the Output Side Upgrade Cover
Tools needed: Press the Release tab with a flat blade. Use the Snap and Clip process.
Estimated Repair Time: 1 minute
Step Procedure
1
Caution: Power off the Printer by unplugging the power cord from
the Printer.
2 Press the release tab in back while simultaneously pulling at the center of the
bottom edge.
3 Reverse instructions to re-assemble. Leave it off if your printer is upgraded for
the Flipper or Lamination Module.