beautypg.com

Using the print top of form option, Using the print top of form option -16 – FARGO electronic HDP5000 User Manual

Page 325

background image

RESTRICTED USE ONLY

Fargo Electronics, Inc.

HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.3)

9-16

Using the Print Top of Form Option

Follow these instructions:

Step Procedure

1

Verify the Transfer TOF is set to +35.

2

Verify the Print TOF is set to +20.

3

Verify the Print LOF is set to +7.

4

Print the alignment card self-test (The front edge should look like Figure
below).

5

Determine which grid line to the left of the center Transfer Alignment Block is
closest to the edge of transfer.

6

Align the leading edge of the center Transfer Alignment Block with the Edge of
Transfer.

• To do this adjust the Print TOF setting up or down by the number located

directly to the right of the line found in the previous step.

• To help with this setting there are (+/-) orientation arrows located at the

upper and lower left sections of the card.