FARGO electronic HDP5000 - Manual (Page 7)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4) vii
Reviewing the ISO Track Locations__________________________________________________ 8-77
Sending the Track Information ______________________________________________________ 8-78
Reviewing the Sample String _______________________________________________________ 8-79
Reviewing the ASCII Code and Character Table ________________________________________ 8-80
Using the Default button (Image Transfer tab)__________________________________________ 8-81
Using the Lamination tab (HDP5000-LC) ________________________________________8-82
Selecting the Lamination Position ___________________________________________________ 8-83
Adjusting the Lamination Speed - Transfer Dwell Time __________________________________ 8-84
Selecting the Lamination Side dropdown menu _________________________________________ 8-85
Reviewing the Card Lamination Module Unit table (No Flipper versus Flipper) _______________ 8-86
Selecting the Lamination Type ______________________________________________________ 8-87
Adjusting the Lamination Temperature _______________________________________________ 8-89
Selecting the Defaults button _______________________________________________________ 8-90
Using the K Panel Resin tab ____________________________________________________8-91
Using the Scroll controls __________________________________________________________ 8-92
Using the Click and Drag capability__________________________________________________ 8-93
Selecting “inches or mm” radio button________________________________________________ 8-93
Using the Add and Delete buttons ___________________________________________________ 8-93
Selecting the Full Card ____________________________________________________________ 8-94
Selecting the Defined Area(s)_______________________________________________________ 8-95
Selecting the Undefined Area(s)_____________________________________________________ 8-96
Defining the Area to activate the Card Grid ____________________________________________ 8-97
Measuring the Total Card area ______________________________________________________ 8-98
Measuring the Area to be positioned on the Card________________________________________ 8-99
Selecting the Print YMC under the K and Print K Only options ___________________________ 8-100
Using the Printer Supplies tab _________________________________________________8-102
Reviewing Information on the Supplies tab ___________________________________________ 8-103
Section 9: Toolbox_________________________________________________________ 9-1
Accessing the Toolbox _______________________________________________________________ 9-1
Selecting the Configuration tab _________________________________________________________ 9-2
Using the Configuration Tab ___________________________________________________________ 9-3
Using the Optional Printer Features Group Box__________________________________________ 9-3
Using the Event Monitoring Group Box __________________________________________________ 9-4
Reviewing the Ribbon Low message __________________________________________________ 9-4
Reviewing the Laminate Low Message ________________________________________________ 9-5
Using the Film Low message ________________________________________________________ 9-6
Selecting the Set Language for Printer LCD Display Group Box ____________________________ 9-6
Selecting the Calibrate Laminator tab ____________________________________________________ 9-7
Selecting the Calibrate Film tab ________________________________________________________ 9-8
Selecting the Calibrate Ribbon tab ______________________________________________________ 9-9
Selecting the Clean Printer tab ________________________________________________________ 9-10
Using the Clean Printer Group Box __________________________________________________ 9-12
Selecting the Advanced Settings tab ____________________________________________________ 9-13
Using the Image Darkness Option ___________________________________________________ 9-15
Using the Print Top of Form Option__________________________________________________ 9-16
Using the Print Left of Form Option _________________________________________________ 9-18
Using the Mag Top of Form Option __________________________________________________ 9-19
Using the Print Flip Angle Option ___________________________________________________ 9-21
Using the Print Flip Level Option ___________________________________________________ 9-21
Using the Encoder Flip Angle Option ________________________________________________ 9-21
Setting the Printhead Resistance_____________________________________________________ 9-21
Using the Transfer TOF Adjustment Option ___________________________________________ 9-22
Using the Transfer Temp Offset Option _______________________________________________ 9-25