Using the transfer temp offset option, Print tension settings, Using the ribbon print takeup tension option – FARGO electronic HDP5000 User Manual

Page 334: Using the film print takeup tension option, Using the transfer temp offset option -25, Print tension settings -25, Using the ribbon print takeup tension option -25, Using the film print takeup tension option -25

RESTRICTED USE ONLY

Fargo Electronics, Inc.

HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.3)

9-25

Using the Transfer Temp Offset Option

This option adds an offset to the temp the printer is reading from the transfer roller. (Note:
This setting should be used only make the temp of the transfer roller and the goal on LCD
match.)

• Use the slider on “Image Transfer” tab to make adjustment for card stock. (Note: A “-”

Adjustment will increase the actual temp of roller.)

Print Tension Settings

Using the Ribbon Print Takeup Tension Option

This procedure controls the tension of the color Ribbon during printing.

• Adjust the Ribbon tension if the Ribbon wrinkle is appearing on the card. (Note:

Adjustments moderately change the image length.)

Using the Film Print Takeup Tension Option

Caution: The Film Drive sets the baseline for the Film Tension and should not be adjusted
by the reseller or the end User.

• Adjustments moderately change the image length.)