FARGO electronic HDP5000 - Manual (Page 148)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4) 6-19
Switching to the Automatic IP Address Mode
Step Procedure
1 Select the Network link from any web page of the Printer.
2 Select the Obtain an IP address automatically radio button to enable the
DHCP/BOOTP, which automatically assigns the network settings.
Even with this button selected, the User can enter Stored Settings, and the
Stored Settings will remain in memory. See below. (Note: This is the default
method.)
3 Click on the Submit button to save this setting.
4 Login as a root User if you are so prompted. (Note: Any change of setting
will only be accepted after you have successfully logged in.)
5 Reboot the Printer to affect this change.