Fujitsu Siemens Computers SPARC Enterprise M8000 - Manual (Page 99)

Chapter 4 Practical Examples of DR 4-9
3. Check the status of the system board to be deleted.
Execute the showboards(8) command to display system board information, and
then check the status of the system board to be deleted.
4. Delete the system board.
Execute the deleteboard(8) command to delete the system board and pool it in
the system board pool.
5. Check the status of the domain and deleted system board.
When the deleteboard(8) command ends normally, execute the showdcl(8)
command to check the operation status of the domain, and then execute the
showboards
(8) command to check the status of the deleted system board.
If the deleteboard(8) command completes abnormally or leaves the board in an
unwanted status, refer output messages to identify the problem, then correct it.
XSCF> showboards -a
XSB DID(LSB) Assignment Pwr Conn Conf Test Fault
-------------------------------------------------------------------
00-0 00(00) Assigned y y y Passed Normal
01-0 00(01) Assigned y y y Passed Normal
XSCF> deleteboard -c unassign 01-0
XSCF> showdcl -d 0
DID LSB XSB Status
00 Running
00 00-0
01 01-0
XSCF> showboards -a
XSB DID(LSB) Assignment Pwr Conn Conf Test Fault
----------------------------------------------------------------
00-0 00(00) Assigned y y y Passed Normal
01-0 SP Available y n n Passed Normal