Fujitsu Siemens Computers SPARC Enterprise M8000 - Manual (Page 114)

4-24 SPARC Enterprise Mx000 Servers Dynamic Reconfiguration User’s Guide • September 2007
3. Check the status of the move-destination domain.
Execute the showdcl(8) command to display domain information, and then
check the operation status of the move-destination domain. Based on the
operation status of the move-source and move-destination domains, determine
whether to perform the DR operation or change the domain configuration.
4. Check the status of the system board to be moved.
Execute the showboards(8) command to display system board information, and
then check the status of the system board to be moved.
5. Reserve the move of the system board.
Execute the moveboard(8) command to reserve deletion of the system board
from the move-source domain and addition of the system board to the move-
destination domain.
6. Check the reserved status of the system board.
Execute the showboards(8) command with the -v option specified to display
system board information, and confirm that moving the system board to the
move-destination domain has been reserved.
7. Stop the move-source domain.
Stop the move-source domain. This operation executes the reserved deletion of
the system board from the move-source domain as a change in domain
configuration, and the reservation of the addition of the system board to the
move-destination domain.
XSCF> showdcl -d 0
DID LSB XSB Status
00 Running
00 00-0
01 00-1
02 01-0
XSCF> showboards 01-0
XSB DID(LSB) Assignment Pwr Conn Conf Test Fault
------------------------------------------------------------------
01-0 01(00) Assigned y y y Passed Normal
XSCF> moveboard -c reserve -d 0 01-0
XSCF> showboards -v 01-0
XSB R DID(LSB) Assignment Pwr Conn Conf Test Fault COD
--------------------------------------------------------------------------
01-0 * 01(00) Assigned y y y Passed Normal n