Fujitsu Siemens Computers SPARC Enterprise M8000 User Manual
Page 138
A-22
SPARC Enterprise Mx000 Servers Dynamic Reconfiguration User’s Guide • September 2007
[Explanation] An unknown resource type was found in the resource list that is
being freed while the board is unprobed.
[Remedy] Please contact customer service.
VM viability test failed: dr@0:SBX::memory
[Explanation] There is not enough real memory to detach memory on system
board X.
[Remedy] Check the amount of available real memory, and repeat the action.If
this error message appears again, please contact our customer service.
DR parallel copy timeout
[Explanation] Internal error happened during kernel migration.
[Remedy] Retry and if the problem persists, contact customer service.
SCF busy
[Explanation] SCF was busy during kernel migration.
[Remedy] Retry and if the problem persists, contact customer service.
SCF I/O Retry Error
[Explanation] Internal error happened during kernel migration.
[Remedy] Please contact customer service.
FMEM command timeout
[Explanation] Internal error happened during kernel migration.
[Remedy] Please contact customer service.
Hardware error
[Explanation] Internal error happened during kernel migration.
[Remedy] Please contact customer service.
FMEM operation terminated
[Explanation] Internal error happened during kernel migration.
[Remedy] Please contact customer service.
Memory copy error
[Explanation] Memory copy error happened during kernel migration.
[Remedy] Retry and if the problem persists, contact customer service.