Quick configuration guide, Registering your fortinet product, Planning the configuration – Fortinet FortiGate 5001A-SW User Manual
Page 25
Quick Configuration Guide
Registering your Fortinet product
FortiGate-5001A Security System Guide
01-30000-83456-20081023
25
Quick Configuration Guide
This section is a quick start guide to connecting and configuring a
FortiGate-5001A security system for your network.
Before using this chapter, your FortiGate-5000 series or compatible ATCA chassis
should be mounted and connected to your power system. In addition, your
FortiGate-5001A boards should be inserted into the chassis and additional
hardware components (such as AMC cards and SFP transceivers) should be
installed. The FortiGate-5001A boards should also be powered up and the front
panel LEDs should indicate that the boards are functioning normally.
This chapter includes the following topics:
•
Registering your Fortinet product
•
•
Choosing the configuration tool
•
•
•
•
Upgrading FortiGate-5001A firmware
•
FortiGate-5001A base backplane data communication
•
Powering off the FortiGate-5001A board
Registering your Fortinet product
Register your Fortinet product to receive Fortinet customer services such as
product updates and technical support. You must also register your product for
FortiGuard services such as FortiGuard Antivirus and Intrusion Prevention
updates and for FortiGuard Web Filtering and AntiSpam.
Register your product by visiting
and selecting Product
Registration.
To register, enter your contact information and the serial numbers of the Fortinet
products that you or your organization have purchased. You can register multiple
Fortinet products in a single session without re-entering your contact information.
Planning the configuration
Before beginning to configure your FortiGate-5001A security system, you need to
plan how to integrate the system into your network. Your configuration plan
depends on the operating mode that you select: NAT/Route mode (the default) or
Transparent mode.