Hardware installation – Fortinet FortiGate 5001A-SW User Manual
Page 11
Hardware installation
FortiGate-5001A Security System Guide
01-30000-83456-20081023
11
Hardware installation
Before use, the FortiGate-5001A board must be correctly inserted into an
Advanced Telecommunications Computing Architecture (ACTA) chassis such as
the FortiGate-5140, FortiGate-5050, or FortiGate-5020 chassis.
Before inserting the board into a chassis you should make sure the SW-11 switch
is set correctly.
In the available Advanced Mezzanine Card (AMC) double-width module (ADM)
opening on the FortiGate-5001A-DW front panel you can install a supported
FortiGate ADM module such as the FortiGate-ADM-XB2 or the
FortiGate-ADM-FB8.
In the available AMC single-width module (ASM) opening on the
FortiGate-5001A-SW front panel you can install a supported ASM module such as
the FortiGate-ASM-FB4 or the FortiGate-ASM-S08.
This section describes:
•
Changing FortiGate-5001A SW11 switch settings
•
FortiGate-5001A mounting components
•
Inserting a FortiGate-5001A board
•
Removing a FortiGate-5001A board
•
Resetting a FortiGate-5001A board
•
Installing and removing AMC modules
•
!
Caution: If you are installing a FortiGate-RTM-XB2 module you should install the
FortiGate-RTM-XB2 module first, before you install the FortiGate-5001A board to avoid
possible damage. Follow t
to
install the FortiGate-RTM-XB2 module.
!
Caution: Because FortiGate-5001A boards do not support hot swapping AMC modules,
the FortiGate-5001A board must be disconnected from power before you install a FortiGate
AMC module. Also, the FortiGate-5001A-DW left (top) handle must be opened to install a
FortiGate AMC module. See
“Installing and removing AMC modules” on page 20
!
Caution: Do not operate the FortiGate-5001A board with an open AMC opening. For
optimum cooling performance and safety, the AMC opening must contain an AMC slot filler
panel or a FortiGate AMC module.
Note: FortiGate-5001A boards are hot swappable even if the FortiGate-5001A board
contains an AMC module and you have installed a FortiGate-RTM-XB2 module for the
FortiGate-5001A board.