Fortinet FortiGate 5001A-SW - Manual (Page 19)

Hardware installation Removing a FortiGate-5001A board
FortiGate-5001A Security System Guide
01-30000-83456-20081023
19
3 Fully loosen the retention screws on the FortiGate-5001A front panel.
4 Unlock the handles by squeezing the handle locks.
5 Open the handles to their fully open positions.
You need to open the handles with moderate pressure to eject the board from the
chassis. Pivoting the handles turns off the microswitch, turns off all LEDs, and
ejects the board from the chassis slot.
6 Pull the board about half way out.
7 Turn both handles to their fully-closed positions.
8 Carefully slide the board completely out of the slot.
9 Re-attach the protective metal frame before shipping or storing the
FortiGate-5001A board.
Loosen
Retention
Screw
!
Caution: To avoid damaging the lock, make sure you squeeze the handles fully to unlock
them before opening. The handles should pop easily out of the board front panel.
Handle
Alignment Pin
Open
Alignment Pin
Lock
Handle
Fully Closed
and Locked
Alignment Pin
Handle
Close
Alignment Pin
Handle