FujiFilm 4500N - Manual (Page 59)

50
● To change the time required for the machine to switch into the power saving mode*, follow the
procedure below.
● The time can be set at 10 minutes, 30 minutes, and 60 minutes.
● The standard setting is 10 minutes. (The 10-minute setting is recommended.)
* Power saving mode: When the machine is left unoperated for a predetermined period of time (10, 30, or 60 minutes),
the machine enters power saving mode in order to conserve energy. The machine exits power
saving mode when any key on the operation panel is pressed, or the machine receives a print
command from the host computer.
1 . Press the ONLINE key on the operation panel to switch the
machine to OFFLINE condition.
2 . When the machine is in OFFLINE mode, press the NEXT
key twice.
★ The message changes to "Configuration".
3 . Press the SEL key.
★ The message changes to "Size".
4 . Press the NEXT key.
★ The message changes to "StandBy".
5 . Press either the + or – key to select the time.
★ Each time the + key is pressed, the time changes as
follows.
10
→
30
→
60
→
10
→
...
★ Each time the – key is pressed, the time changes as
follows.
10
→
60
→
30
→
10
→
...
6 . Press the ONLINE key to return the machine to ONLINE
condition.
4.4 Changing the Power Saving Mode Timer Setup
Configuration
ESC
PREV
SEL
NEXT
Size
ESC
PREV
SEL
NEXT
[ ]
DP +
[ ]
–
StandBy
ESC
PREV
SEL
NEXT
[ ]
10min +
[ ]
–
StandBy
StandBy
StandBy
[ ]
10min +
[ ]
–
[ ]
30min +
[ ]
–
[ ]
60min +
[ ]
–