FujiFilm 4500N User Manual
Page 102
93
6
DONOR/RECEIVER J
AM CLEARING
PR
OCEDURES
Transfer display
Coutermeasure
Remove the magazine. Pull out the donor's leading edge about 2 cm and insert the
magazine again.
IMPORTANT:
If the leading edge is torn or bent, cut off the torn or bent portion with
scissors or the like.
If the donor magazine cannot be pulled out, pull the “J12” knob
(manual cutter) out and in to cut off the donor, pull out the magazine,
and close the cover. The remaining paper is discharged into the donor
insertion section.
2
Rotate the "J1" knob in the direction indicated by the arrow.
Open the left-hand upper side door and open the "J2" guide.
3
Open the thermal processing unit with "J11", and then open the right-hand side upper
door.
Rotate the "J3" knob in the direction indicated by the arrow.
4
Open the thermal processing unit with "J11" and rotate the "J4" knob in the direction
indicated by the arrow.
Pull out the refuse compartment and open its top section.
Pull out the leading edge from the lower side of the thermal processing unit.
5
Rotate the "J5" knob in the direction indicated by the arrow.
7
Open the thermal processing unit with "J11", and then open the right-hand side upper
door.
Rotate the "J7" knob in the direction indicated by the arrow.
8
Open the thermal processing unit with "J11" and then open the right-hand side upper
door.
Open the "J8" guide.
9
Pull out the refuse compartment and open its top section.
Open the "J9" guide.
10
Open the left-hand side lower door and open the "J10" guide.
WARNING: If donor/receiver jamming is accompanied by the emission of smoke, immedi-
ately turn the power switch to OFF ( ), disconnect the power plug from the
power outlet, and contact your dealer.
IMPORTANT:
●
When removing a jammed donor or receiver, use care not to tear it. If you do,
be sure to remove all the pieces of donor/receiver from the machine.
●
After clearing a jam, properly close the doors. If you don't, the machine will not
become enabled for printing. If the doors are left open for an extended periods,
dust may enter the machine, or the donor may be exposed.
●
Do not open the inner door unless necessary. Opening the inner door exposes
the donor's leading end to extraneous light.
●
If the donor magazine is removed during donor/receiver jam clearing, the
exposed portion of the donor's leading end will be automatically cut off and
discharged after the jam is cleared.
D
R
(+1)
(+6)
6.1 Clearing Donor/Receiver Jams